Fisher Scientific Fisher Sei 100L Gravty, Operation Manual

Page: 29 / 63

Fisherbrand 50145736 | 21
Start-up | Chapter 5
Installation or Removal of the Support Rails (forced
air oven only)
Figure 5-3. Support Rail Installation
The embossings at [2] and [5] act as lateral guides for the support rails, while the embossings at
[1] and [6] secure the support rails in place. For the support rails to install correctly the retaining
spring [3] must be facing upwards.
1. Place the support rail [4] on the lower embossing [6] and tilt it upwards against the work
space side wall so that the rail is positioned over the two embossings at [5] and [2].
2. Clamp the retaining spring [3] behind the upper embossing [1].
3. To remove the support rails, pull the retaining spring tab down out of the embossing and
remove the support rail assembly.
Installing and Uninstalling the Air Baffles
The following section describes the installation and removal of the air baffles.
Figure 5-4. Removing the Bottom Panel