accumet AE150 pH Benchtop Meter
21 of 28
www.fishersci.com
Storing and Recalling Data from Memory
The Fisher Scientific accumet AE150 pH benchtop meter allows up to 100 data sets to be
stored and recalled in its non-volatile memory in a Last-In-First-Out (LIFO) sequence. Data
sets are stored with a specified location, as indicated on the display. For example, 32 pH
and temperature data sets and 18 mV and temperature data sets can be stored.
Memory Input:
The memory input feature allows measurement readings to be
stored for later review. This mode can be used at any time during
measurement mode or when the reading is frozen (“HOLD” icon is
shown on the display by pressing the
HOLD
key).
1. To store a reading during any measurement or HOLD
function, press the
MI
key to input data into the memory.
2. The “MEM” icon, “StO” and memory number will be shown
briefly on the display.
3. The meter will then return to the measurement mode.
4. To store another reading, press the
MI
key again.
Note:
When the memory is full, the oldest stored data set will be erased to create space for
the new data set.
Memory Recall:
Readings stored in the memory are retained even when the meter is
powered off. To erase all readings stored in memory, use the P1.0
program in the setup mode.
1. In the measurement mode, press the
MR
key to retrieve the
most recent stored reading.
2. The memory location screen with “MEM” icon, “LOC” and the
memory number will be shown on the display.
3. Press the
ENTER
key to recall the reading stored under that
memory number.
4. Press the
ENTER
key again to return to the main memory
recall mode.
5. To view additional data sets, press the
or
arrow key to
scroll to the desired data set location.
a. For example, to view the third data set, press the
or
arrow key until “LOC 3” is shown and press the
ENTER
key to view the data from this location.
6. To continue reviewing additional stored data, press the
ENTER
key again.
7. To exit the memory recall mode, press the
CAL/MEAS
key
to return to the measurement mode.
