BFR73 , CHM70
ACTIVATE THE SHUTTLE
BATTLE MODE
Keep these instructions
for future reference as
they contain important
information.
Battery installation is required.
Only adults should install batteries.
Tool required for battery
installation: Phillips screwdriver
(not included).
Periodically wipe each
part of this toy with
a clean damp cloth.
Do not immerse.
Requires seven AA (LR6)
alkaline
batteries (not included)
for operation.
1,5V x 7
AA (LR6)
Remark:
Revision
Date
ID#
Changes
Primary - pr
6/18/2014
BFR73_1100242238_3LA
NA
Revision - a
9/12/2014
BFR73_1100472900_3LA
Add “Small Part Warning”
• For longer life use
alkaline
batteries.
• Locate the battery compartment door on
Rover and the shuttle. Loosen the screw in
each battery compartment door. Remove
each door.
• Insert four AA (LR6)
alkaline
batteries in
Rover and three AA (LR6)
alkaline
batteries
in the shuttle.
• Replace each battery compartment door
and tighten each screw. Do not over-tighten.
• If Rover or the shuttle begin to operate
erratically, you may need to reset the
electronics. Slide each power switch off
and back on.
• If Rover does not respond to the shuttle
when you press the button, or when sounds/
lights become faint or stop, it’s time for an
adult to change the batteries.
• Protect the environment by not
disposing of this product with
household waste (2002/96/EC).
Check your local authority for
recycling advice and facilities.
1,5V x 7
AA (LR6)
Power Up!
Battery Installation
Battery Safety Information
In exceptional circumstances, batteries
may leak fluids that can cause a chemical
burn injury or ruin your product. To avoid
battery leakage:
• Do not mix old and new batteries or
batteries of different types: alkaline,
standard (carbon-zinc) or rechargeable
(nickel-cadmium).
• Insert batteries as indicated inside the
battery compartment.
• Remove batteries during long periods
of non-use. Always remove exhausted
batteries from the product. Dispose of
batteries safely. Do not dispose of this
product in a fire. The batteries inside
may explode or leak.
• Never short-circuit the battery terminals.
• Use only batteries of the same or
equivalent type, as recommended.
• Do not charge non-rechargeable
batteries.
• Remove rechargeable batteries from
the product before charging.
• If removable, rechargeable batteries are
used, they are only to be charged under
adult supervision.
Slide the power switch on
Rover ON
or OFF
.
1-800-432-5437 (US & Canada)
1300 135 312 (Australia)
Fisher-Price, Inc., 636 Girard Avenue, East Aurora, NY 14052.
Hearing-impaired consumers: 1-800-382-7470.
Outside the United States:
Canada: Mattel Canada Inc., 6155 Freemont Blvd.,
Mississauga, Ontario L5R 3W2; www.service.mattel.com.
Great Britain: Mattel UK Ltd, Vanwall Business Park,
Maidenhead SL6 4UB. Helpline: 01628 500303.
www.service.mattel.com/uk
Mattel Europa B.V., Gondel 1, 1186 MJ Amstelveen, Nederland.
Australia: Mattel Australia Pty. Ltd., 658 Church Street,
Locked Bag #870, Richmond, Victoria 3121 Australia.
New Zealand: 16-18 William Pickering Drive,
Albany 1331, Auckland.
FCC STATEMENT (UNITED STATES ONLY)
This equipment has been tested and found
to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC
rules. These limits are designed to provide
reasonable protection against harmful
interference in a residential installation.
This equipment generates uses and can
radiate radio frequency energy and, if not
installed and used in accordance with the
instructions, may cause harmful interference
to radio communications. However, there
is no guarantee that interference will not
occur in a particular installation. If this
equipment does cause harmful interference
to radio or television reception, which can
be determined by turning the equipment
off and on, the user is encouraged to try to
correct the interference by one or more of
the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the
equipment and receiver.
• Consult the dealer or an experienced radio/
TV technician for help.
NOTE: Changes or modifications not
expressively approved by the manufacturer
responsible for compliance could void the
user’s authority to operate the equipment.
This device complies with Part 15 of the
FCC Rules. Operation is subject to the
following two conditions: (1) This device
may not cause harmful interference, and
(2) this device must accept any interference
received, including interference that may
cause undesired operation.
CAN ICES-3 (B)/NMB-3 (B)
• Operation is subject to the following
two conditions: (1) this device may
not cause interference, and (2) this
device must accept any interference,
including interference that may cause
undesired operation of the device.
• L’utilisation de ce dispositif est
autorisée seulement aux conditions
suivantes : (1) il ne doit pas produire
de brouillage et (2) l’utilisateur du
dispositif doit être prêt à accepter
tout brouillage radioélectrique
reçu, même si ce brouillage est
susceptible de compromettre le
fonctionnement du dispositif.
Load the disks into the launchers on the shuttle.
Remove the shuttle from Rover.
Aim the shuttle at Rover and press the button to fire!
Listen for the voice prompt. Then, press the
red
button on Rover to sound the alarm!
Press the button on the shuttle to fire at
Rover again!
Listen for the voice prompt. Then, press the
yellow
button on Rover to activate the shields.
Listen for the voice prompt. Then, press the
green
button on Rover to rev up for more power.
Press the button on the shuttle a third time to
take Rover down!
Place the shuttle on Rover.
Place a figure in the disk on the back end of Rover ....
...to lift off...
...and automatically fire the disks!
Place a figure in the disk on the back end
of Rover. Turn and hold to lower the shuttle.
WARNING
Do not aim at eyes
or face. Only use
projectiles supplied with
this toy. Do not fi re at
point blank range.
WARNING:
CHOKING HAZARD
– Small parts.
Not for children under 3 years.
Rover
Shuttle
©2014 Mattel. All Rights Reserved.
PRINTED IN MEXICO
1100472900
Slide the power switch on
the bottom of the shuttle
ON
or OFF
.
Power Switch
