Fisher & Paykel WL4027P1 Solving Operating Problems Download Page 1

Page: 1 / 3

Solving Operating Problems

Pressing POWER Does Not Turn ON Washer

• Is the power switched on at the wall?

• Unplug from wall. Wait 60 seconds, plug back in, turn on and try again.

• Could household power supply be at fault? Try plugging in another appliance in the same power socket.

• Keylock mode may be activated. Try holding down the POWER button for 3 seconds (refer to page 18).

Pressing START/PAUSE Does Not Start the Fill

• Are both hot and cold faucets turned on?

• Are the inlet hose filters blocked? Check both ends of the hoses.

• Is DELAY START set? (selected models only).

Filling Continuously

• Ensure drain hose is located in the standpipe or tub / sink.

• Ensure standpipe or tub / sink is at least 33 1⁄2” (850 mm) high but no more than 95” (2413 mm) high.

• Check that the washer is not siphoning (refer to page 9).

Not Spinning Properly

• Ensure load is not out of balance.

• Check washer is level and does not rock in any direction.

• Ensure washer does not have suds build up.

• Check that the washer is not siphoning (refer to page 9).

Spin Speed Sounds Slower than Normal

• Clothes are unevenly distributed in the wash basket, your washer has slowed the spin to compensate.

Updated: Tue, 16 Nov 2021 11:38:57 GMT

Summary of Contents for WL4027P1

Page 1: ...models only Filling Continuously Ensure drain hose is located in the standpipe or tub sink Ensure standpipe or tub sink is at least 33 1 2 850 mm high but no more than 95 2413 mm high Check that the w...

Page 2: ...verloaded causing splash from clothes as washer filled Try reducing load size or select BULKY cycle for large bulky items Wash Cycle Time longer than Usual If water pressure is low cycle time will inc...

Page 3: ...spenser refer to page 41 If the dispenser is at MAX level at the completion of the cycle check for and clear any blockages Noises Banging the load is out of balance Continuous beeping or a musical ser...