Fisher & Paykel WL26CW1, Service Supplement Manual

Page: 34 / 41

517794B
34
Reassembly:
(a) Prior to fitting the neck ring, ensure the
recirc nozzle is fitted to the outer bowl
correctly.
(b) Fit the straps to the neck ring.
(c) Fit the neck ring to the outer bowl,
ensuring that all the clips are engaged.
(d) Fit the straps to the suspension rods
ensuring and that there are no twists in
the straps.
Note: The top of the nozzle must be dry
before fitting the neck ring. If any water is
present, a capillary action may take place
which will cause water to run down the
outside of the bowl and onto the floor.
17.10 Removal of Low Profile Agitator
Note: Removal of low profile agitator is not
intended to be done by the user, as regular
maintenance in this area should not be
required.
(a) Lift the lid and remove the low profile
agitator cap by using an appropriate flat
bladed screwdriver in one side of the
slots. Lever the cap upwards until it
disengages. The cap can then be
removed by hand.
(b) Remove the bolt by turning anti-clockwise
using a 13mm open-ended spanner or an
adjustable spanner.
(c)
Remove the low profile agitator.
Note: If the low profile agitator does not lift
off easily, hold the top balance ring of the
inner bowl, then jerk the bowl upwards. This
action will push the agitator upwards.
The top of the nozzle must be
dry before refitting the neck ring