Using your water dispenser – Ice & Water models
Before using your water dispenser
Ensure your ice and water system has been correctly installed by following the installation instructions booklet supplied.
To flush the water filtration system:
• Ensure your refrigerator is switched on, and the isolation tap has
been connected and turned on.
• Run your water dispenser pad until water dispenses, this will
displace trapped air in the water tank and filter system. This will
take at least 2 minutes. Once water has dispensed, rest the
dispenser pad for 2 minutes.
• Dispense and discard 4 litres of water, then rest the dispenser pad
for a further 2 minutes.
• Dispense and discard a further 4 litres of water. Failure to do this
will result in excessive dripping from your dispenser.
• Please note, once installation is complete a few drips may appear
out of the dispenser over the next few days to clear the remaining
trapped air.
• Ensure your refrigerator has cooled for at least 2 hours before
use.
Water dispenser
You are now ready to enjoy water from your water dispenser.
Dispensing
• Your water dispenser has been designed for one-handed operation.
• To dispense water, gently press the dispensing pad using a glass or container.
• To stop the flow of water, simply pull your glass away from the dispensing pad.
• Please remember that pressing very hard against the dispensing pad will not encourage the dispenser to
operate faster or produce greater quantities of water.
Updated: Mon, 16 Mar 2020 12:54:48 GMT
Powered by
1
