39
@4
INSTALL FLOW DIVIDER AND DOOR TRIMS
Required components/tools:
●
●
1x Door flow divider
●
●
1x Flow divider cap
●
●
1x 8Gx16 Countersunk screw
●
●
2x Trim caps
●
●
Top door panel extrusion
●
●
2x Door panel side extrusion
●
●
Saw
●
●
File
IMPORTANT!
The door flow divider is pre-assembled to the door of the appliance. It blocks the air flow
from bypassing in front of the bottom grille.
Install the flow divider
1
Peel the adhesive layer off the flow divider (
A
).
2
Remove the 8Gx16 countersunk screw from the bottom of the door and
re-install the flow divider using the same screw. (Do not tighten fully) (
B
).
3
Press the flow divider firmly against the door panel (
C
). Make sure the
adhesive layer contacts the door panel.
4
Re-tighten the screw fully.
Expose adhesive
Exploded with machine screw
Twist to prise open
Cut airflow divider for 6” toekick
E
Install the door trims
1
Insert two (2) trim caps (
E
) into the top door
panel extrusion.
2
Align the notch on the top door panel extrusion
(
F
) with the magnet housing at the top of the
door (
G
) and clip door top trim assembly into the
magnet housing.
3
Press the top door panel extrusion down into the
top of the door (
H
) so that the dual lock strips
engage together.
Note: When fitting the air flow divider to the
door for a toe kick height greater than 4”
(102mm), the divider requires shortening. This
is done by cutting along the cutline on both the
divider and divider cover (
E
) before installation
to the door. Ensure to file the cut portions of the
divider and cover.
5
Attach the flow divider cap to the flow divider (
D
).
B
C
D
A
4
Press the door panel side extrusion (
I
) into the gap between the door and door panel. Align
the top of the door panel side extrusion with the top door panel extrusion. Do on each side.
I
I
I
I
H
H
E
F
G
E