Fisher & Paykel Intuitive DE62T27GW, Service Manual

Page: 9 / 25

517762
9
5.3 Removal of Display Module
(a) Follow instructions for removal of the console.
(b) Disconnect the wiring harness from the display module.
(c) Remove the 3 screws securing the display module to the
console.
(d) Using a flat bladed screwdriver, push the two top tabs
that secure the display module to the facia.
(e) When these tabs are clear, lift the right hand end of the
module and slide in the direction shown.
6 DIAGNOSTICS
6.1 Overview
If a fault occurs that prevents correct operation
of the dryer, and is detected by the controllers,
the dryer is stopped, the LCD shows a fault
code and the beeper is continuously turned on
and off.
Pressing any button once will disable the
beeping. The fault code information will remain
on the LCD screen until the power supply to the
dryer is turned off.
If the Dryer has been either turned off or isolated from the power supply the fault code can be
recalled from memory by entering diagnostic mode refer to Section 7.1.
If Start/Pause is pressed while the fault code is displayed the beeping will stop and the optical
download is activated refer Section 7.1.4.
User Warnings
In the case of User Warnings, the LCD screen will display the User Warning and the beep tone will
change from a continuous tone to a musical series of beeps, which are repeated every 5 seconds.
Slide after clearing top tabs