Troubleshooting
Fault / Error
What to Do
Excessive water remaining above the filter plate,
after the rinse cycle. (This is displayed as an A3
fault. See user guide ‘How to attend to a fault’)
Check for a kinked drain hose, blocked or incorrectly drilled
out waste connection, highloop not properly installed, drain
hose not routed correctly or spray arms not in place.
No water supply. (This is displayed as an A1 fault.
See user guide ‘How to attend to a fault’)
Check water is connected and turned on.
The dishwasher is beeping continuously
There is a fault. See section ‘How to attend to a fault’ in the
User guide for further information and instructions.
No program indicator lights up when the drawer
is opened
Ensure power is connected and is switched on. If it is and
still no indicator ligths up, see the ‘Preference options’
section of the ‘Quick start guide’.
An option called ‘Open drawer auto power-on’ may need to
be turned on.
Water around water supply and drainage
connections
Check connections, existing plumbing and hoses for leaks.
Check rubber washer and hose clamp are correctly fitted.
If product is tipping
Ensure the product is secured to the cabinetry.
If front panels are misaligned
Check and relevel product. Check the cabinetry is square.
For Integrated models, check and adjust front panel
alignment if necessary.
Drawer doesn’t close properly
Ensure nothing is obstructing the drawer from closing
properly eg hoses or drawer latches.
• If a problem occurs, consult the ‘Troubleshooting’ section of the User guide.
• If after checking these points you still need assistance, please refer to the Service & Warranty book for warranty
details and your nearest Authorized Service Center, or contact us through our website www.fisherpaykel.com
Updated: Tue, 16 Nov 2021 11:45:40 GMT
Powered by
1
