12
Installation test cycle
IMPORTANT!
Ensure the installation test cycle is completed before you dry any
items in your dryer. This is to check that your dryer is installed
correctly and that it is functioning properly prior to use.
1
Turn your dryer on by pressing the ‘Power’ button.
2
Select the ‘Time Dry’ cycle for 30 minutes. Ensure the drum is empty
and the door is closed (you will hear it click shut).
3
Touch the button. The drum will start rotating.
●
●
Observe the dryer for any problems.
●
●
The dryer will beep and display any faults on the screen if there are
any problems. Refer to page 20-21.
4
At the completion of the cycle open the door and check that there is
warmth inside the dryer. This indicates the dryer is operating normally.
IMPORTANT!
If there are any problems, you must address these before proceeding
with normal use. The dryer will automatically turn off at the end of
the cycle if there are no problems.
Before you start, it is a good idea to go through the following
checklist:
1
Has the packaging been removed?
2
Is the lint filter correctly in place?
3
Has the power cord been connected to an appropriate power supply
and the power turned on?
4
Have you performed the installation test cycle?
2.4 Completing the installation
