CAVITY PREPARATION
Anti tip bracket kit
Anti-tip bracket (1x)
Masonry plug (4x)
#10x40
Pan Head
Philips S
cr
ew
#10x40
Pan Head
Philips S
cr
ew
#10x40 cross-head
screw (4x)
Tools
Cross-head screwdriver
Powered driver (optional)
Pencil
z
The anti-tip bracket and fittings supplied must be fitted to the wall
of the finished enclosure to withstand 100kg load.
z
Ensure that anti-tip bracket is installed correctly to prevent the
appliance tipping forward when door is open.
z
Ensure the bracket is secured to structural beams or wall studs
nearest to the center of the alcove.
WARNING!
Read the following before securing with masonry plugs and / or screws:
z
Ensure the screws avoid electrical, gas and water conduits.
z
Ensure lightweight masonry material such as cinder block and new concrete
(no curing time) are not used in installation.
z
Do not use metallic materials that may corrode, stain and / or
damage the enclosure.
min 7 3/4"
(197mm)
bracket
A
B
For solid wall installation
Drill holes suitable to the size of the
masonry plugs.
Hammer masonry plugs into wall until
flush. Fix bracket to wall with #10x40mm
cross head screws, and screw tightly.
For plaster board wall
Fix the anti-tip bracket to the wall with
#10x40mm cross head screws, and screw
tightly with a screwdriver.
1
2
3
4
5
Project horizontally from the
bottom edge of the finished
enclosure towards the center of
the back wall (
A
).
This will locate the contact
surface between the bracket and
appliance.
Mark a horizontal line (
B
) at the
back wall.
z
Ensure there is a stud behind
the wall.
Place the bracket to the backwall.
Align the undersurface of the
bracket along the marked line.
Mark screw hole locations, and drill
screw holes with powered drill.
When rollng the appliance into the
cabinetry, ensure the anti-tip bracket
overlaps the back edge of the appliance.
z
The bracket must overlap the appliance
by a minimum 7 1/16" (180mm) for a
secure hold.
If minimum 7 1/16" (180mm) overlap
cannot be achieved, install a solid spacer
to the wall stud behind the bracket.
z
Be careful not to run over the power
cord when rolling in the appliance.
21
