18
F
D
E
Water fittings kit
Collet locking clip
(1)
1/4" (6mm) adaptor
(1)
1/4” (6mm) Stainless
steel braided hose with
adaptor (1)
6
At the back of the appliance, connect the
free end of the braided hose to the water supply
(
E
), and then loosely coil the water line hose
(~2 – 3 times).
– Do not over-tighten the connection.
– Turn ON the water supply and check that
all connections are dry and free of drips.
Connect to power supply
7
Locate the power cord and connect the fitted
plug to the electrical supply (115VAC, 60Hz) (
F
).
Turn ON the appliance to test if working.
– If using an isolating switch, turn OFF the
appliance before continuing the installation.
IMPORTANT!
●
●
Ensure that the water connection is performed by a professional installer.
●
●
The standard appliance includes a braided water line hose compatible
with a brass adaptor.
●
●
Ensure there is enough tubing for the water connection and to pull
the appliance out for service, if required.
●
●
Flush water through the hose prior to connection to the appliance
to remove any debris in the hose.
●
●
We recommend to use an isolating switch that can be accessed
easily after the appliance is installed.
!4
WATER AND POWER SUPPLY CONNECTION
Connect to water
(for Ice and Water models only)
1
Move the appliance in front of the
cabinetry close enough to allow access
behind for power and water connections.
2
At the front of the appliance, insert the
adaptor of the braided water line hose
(
A
) into the PRV.
Note: If using a 1/4 PEX plastic tubing,
you need to use a water fittings kit (not
supplied and must purchase separately).
C
3
Insert the tube end of the adaptor fully
into the PRV. Once inserted, pull gently
on the tubing to ensure it is locked in (
B
).
Note: Dislodge the PRV from the clips,
if required.
4
Secure the connection by inserting a
locking key between the PRV and tube
end of the adaptor (
C
).
– If the PRV is dislodged during
installation, mount the PRV back
into the clip.
5
Thread the free end of the water line hose
into the hole located at the base and
through the back of the appliance (
D
).
PRV
adaptor
PRV
B