38
MMS
®
Inspection SPG High
Glossary
11 Glossary
ASTM 4417, Method B
Measurement method for measuring the height of surface profile. The peak-to-
trough height differences according to standards are measured.
The profile height value is determined in 10 measurements. Depending on the
directive or guideline according to which the test is being carried out, you can
set in the gage which value of the 10 measurements is to be displayed and
saved.
Principle for measuring the height of surface profile with the device model MMS Inspec-
tion SPG in sectional view.
Batch
A file for organizing and controlling the measurement data.
All the settings rel-
evant to the measurement and the measured readings themselves are saved in
a file. In the gage, such a file is marked as a batch. In the batch, you define
the measurement procedure, e.g. whether the specification limit is to be mon-
itored during the measurement or whether the measured readings are to be
logged in measurement block groups.Each batch file is assigned to
Calibration
001, which are referenced to the measurements.
Foil
see under Calibration standards
Calibration shim
see under Calibration standards
Calibration standards
•
Glass plate from scope of supply. Needed for adjustment to the profile
height 0 (zero = zero point).
Probe tip
Support ring
Surface profile
Probe tip