FISCHER Mess- und Regeltechnik GmbH
Operation | 5
BA_EN_FT90
71/108
5.5.1.5 Colour change C1
Path: \Configuration\Channel 1\Colour change C1
Level: 3
\...\...\Colour change C1
1
2 3
4
Col.ch. C1 red–grn
Col.ch. C1 grn–red
Col.ch. C1 red–ylw
Col.ch. C1 ylw–grn
U
Fig. 101:
Colour change C1
This menu is used to set the switch threshold for the colour change of the back
lighting. A pre-requisite for the efficiency of the switch thresholds is the activa-
tion of the colour change in the menu LCD colour and its assignment to measur-
ing channel K1 in the menu Col.ch. assignment.
Menu name
Description
Col.ch. C1 red–grn
Switching thresholds for the named
colour change
Col.ch. C1 grn–red
Col.ch. C1 red–ylw
Col.ch. C1 ylw–grn
Col.ch. C1 grn–ylw
Col.ch. C1 ylw–red
Col.ch. C1 hyst..
This parameter can be used to set an
hysteresis for all switch thresholds.
Col.ch. C1 delay on
This parameter can be used to set an
activation delay for all switch
thresholds.
Col.ch. C1 delay off
This parameter can be used to set a
deactivation hysteresis for all switch
thresholds.
Back
E
This represents the output (exit) of the
menu. Press 'back' to return to the
Channel 1 menu.
There are precisely two types of colour change that can be set in the menu
LCD colour
. Depending on this, certain thresholds are ignored. So, for in-
stance, the switching threshold
Col.ch. C1 ylw–grn
is not relevant for the
colour change type red/green.
By means of colour changes, it is possible to signalise certain operating states
by the colour of the back lighting.
