Fischer Panda Panda 25i PMS, User Manual

Page: 119 / 216

Maintenance Instructions
20.7.15 Kapitel/Chapter 7: Maintenance Instructions - Seite/Page 119
7.15 Replacing the V-belt at Kubota 02/05 series
NOTE:Reprehensive procedure The described procedure is representative for Fischer Panda
generators. The original location of the item must be taken
from the generator description of this manual. All
replacements and repairs should be done by a trained
person.
Due to the relatively high ambient temperature inside the closed sound insulation capsule (approx. 85 °C), the useful
life of the V-belt is reduced. It is possible that the plasticisers in the rubber compounds may partially lose their
effectiveness even after a short operating time because the air in the sound insulated capsule can be both relatively
warm and dry.
The V-belt must therefore be checked at very short time intervals. It may be necessary to replace the V-belt after
several weeks because of unfavourable conditions. A replacement interval of 250 operating hours must never be
exceeded. The V-belt should be inspected after 50 operating hours. The V-belt must be considered a wearing part.
Fig. 7.15-1: Alternator fixing screw
1. Loosen the fixing screw above the alternator.
Wrench with width across flats of 12 mm.
01. Fixing screw
Fig. 7.15-2: Alternator fixing screw
2. Loosen the fixing screw below the alternator.
Wrench with width across flats of 12 mm.
01. Fixing screw
01
12
01
12