Fischer Panda 45i pms, User Manual

Page: 192 / 212

General operation
Seite/Page 192 - Kaptitel/Chapter 2: General operation 8.10.14
2.4.2 Setting the brightness of the backlight ("backlight" and "dimtime")
The brightness of the display backlight of the Panda iControl2 panel can be varied in ten increments (0-9). Also, the
display can be dimmed with a timer if no button is actuated on the control panel for a parameter is able period. To
adjust the default brightness and the dimmed brightness, the set-up menu offers the items "backlight 1" (default
brightness) and "backlight 2" (dimmed brightness). These service menu screens are highlighted with the light bulb
symbol:
The period after which the backlight is to switch to the dimmed level can be specified with the menu item "dimtime".
In this screen, you can enter the time in seconds, values between 0s and 255s are
possible.
Note: In the sub-menus, set the desired values with the cursor
buttons, and then confirm your settings with the Start/
Stop button.
After setting all parameters, you can exit the set-up menu with the menu item "Save & Exit". In doing so, all settings
entered in the sub-menus backlight 1, backlight 2, dimtime, and Network ID are saved to the EEPROM. Then, the
goodbye screen appears for 3 seconds, and the controller is switched off.
At the next start of the controller, the changes will take effect.