fisair DFRA Series, User Manual

Page: 60 / 68

User Manual DFRA Series |
60
14.1.2 Assembly
1. To begin, the articulated joint (8) must be
placed on one end of the belt (9). To do
this, insert a screw in the belt so that it
goes through the joint and the belt in the
first hole. The tips of the screws should
not protrude more than 1 mm, to avoid
rubbing against the rotor.
2. The belt (9) must then be wound around
the rotor.
See specific belt length (L) according to model in Table 1
Table 1
To finish coupling of the belt to the traction system, implement the appropriate procedure
for the following, depending on the model:
DFRA 100, 130, 160, 175, 200, 230, 300, 400 and 500.
DFRA Model L (mm)
100 1320
130,160,175,200,230,300 1885
400.500 2590
650.900 3320