Page 22
ADVANCED Operation
ALARM
Hard Drive and USB Options continued:
Formatting the USB Flash Drive
Use a USB flash drive to backup recorded video and upgrade the system`s firmware. You should always format the USB flash
drive you intend to use with the system.
NOTE: Not formatting the USB flash drive may result in improper functionality.
Advanced Setup
Use the ADVANCED SETUP menu to configure alarm settings, motion detection,
mobile surveillance, PTZ settings and network settings. The Advanced Setup
menu contains the following sub-menus: Alarm, Info, MD (Motion Detect),
Mobile, System, PTZ, and Network
Alarm
Alarm and E-mail Options:
Use the Alarm menu to configure alarm and e-mail settings. NOTE: External alarm
devices must be connected to the alarm block on the rear panel of the DVR in order
to use the I/O (input/ output) alarms of the system. See next section “Alarm Inputs”
and “Alarm Inputs Diagram” for details on attaching alarm inputs. To access this
menu, from the MAIN MENU click ALARM.
To configure alarm settings:
1. Under I/O CHANNEL, select NO (Normal Open), NC (Normal Closed), or OFF
for Alarm input. Alarm Input 1 on Alarm Block controls
CH1 1 (Camera 1). Scroll down to view additional channels. Note: If in the
RECORD screen a Channel is set to OFF, ALARM is also disabled for that
Channel.
2. To activate Loss Alarms use drop down menu and select ON/OFF:
•
HDD LOSS: The alarm will sound if the internal HDD is damaged
•
HDD SPACE: The alarm will sound when the HDD is full (overwrite must be disabled)
•
VIDEO LOSS: The alarm will sound when a camera is disconnected
3. Under ALARM MANAGE, configure the following:
•
OUTPUT: Set the output time (in seconds) on the spot monitor from 0s,
10s, 20s, 40s, or 60s.
•
BUZZER: Set the time (in seconds) for the DVR buzzer to sound when
an alarm is triggered—0s, 10s, 20s, 40s, or 60s NOTE: Set the buzzer
to 0s if you want to disable the alarm during motion detection.
•
POST REC: Set the time (in seconds) for the system to record after a
triggered alarm—30s, 1MIN, 2MIN, 5MIN
Advanced Setup Menu
USB Flash Drives
The system is compatible with most major brands of USB flash drives, with capacities from 256 MB to 4 GB. If
you need to reformat your flash drive then click on the U DISK FORMAT button while the USB drive is connected
to the USB port on the front of the DVR. Be aware that this button is not for use with any external USB hard drive
you may connect to the DVR for backup. External hard drives will need to be formatted using the FAT32 format
and this can be done by connecting the drive to the USB port on a PC and reformatting it from there.
Alarm Setup Menu
Alarm Manage Screen