© 2020 Carrier
27
8.2.4
Wi-Fi Access Point Settings
To change the Wi-Fi AP settings, follow these instructions:
•
The Access Point Status Field must be ENABLED to allow connecting to the MB485ETH-CG via
Wi-Fi.
•
Modify the Settings manually as needed, via these fields: Access Point SSID, Access Point
Password, SSID Broadcast, and Channel.
NOTE: The default channel is 11. The default IP Address is 192.168.50.1.
•
Click Update Wi-Fi Settings, then click on the System Restart to restart the Gateway and activate
the Wi-Fi settings.
NOTE: If the FS-GUI was open in a browser via Wi-Fi, the browser will need to be updated with the
new Wi-Fi details before the MB485ETH-CG FS-GUI will be accessible again.
Figure 25: FS-GUI Wi-Fi AP Network Settings
