Firetide HotPort 5020, Installation Manual

Page: 20 / 47

Before you permanently install
12
Note:
If you are not able to get the mesh to send and receive data traffic
indoors, see “Troubleshooting” on page 13.
8. After you finish the tests, remove the staging antennas.
Caution!
Do not use staging antennas outdoors. The staging
antennas are rated for indoor use only. Damage caused from
outdoor use of indoor rated antennas is not covered by product
warranty.
You are now ready to permanently install the node. Next, you have to
attach the coaxial cable assembly that will connect to the outdoor
antenna. See “Preparing a node for outdoor installation” on page 17.
Power Consumption table
Power input from DC supply: 24 W (Typical), 28 W (Max)
Power input from PoE: 24 (Typical), 26 W (Max)
!