Firetide HotPort 5020, Installation Manual

Page: 15 / 47

Before you permanently install
7
For information about cables and accessories approved for use with Firetide
devices, refer to the Firetide Antenna Guide .
Rubber cap Ethernet Port
D/C power
Reset button (behind the
pressure relief valve)
Ground screw
Mount bracket
Ground screw
Firetide nodes must be connected to earth ground. The ground screw is on the
bottom panel between the Ethernet port and the DC power connector.
LEDs
The panel that has the Firetide logo has these LEDs:
•
Radio 1 and Radio 2, which indicate radio status. HotPort 5020-E nodes have
one radio, which is always Radio 1. The Radio 1 LED comes on. The Radio 2
LED is always dark.
• Power, which is a green color when the device receives power. The LED is dark
when the node does not receive power.
Reset button
The reset button is on the bottom panel and is covered by a weatherproof screw.
Antenna connectors
One side panel has three antenna connectors for one radio. For antenna
connectors that you do not intend to use, you need to install 50 Ohm terminators
(not included).