Firetide HotPort 5020, Installation Manual

Page: 14 / 47

Before you permanently install
6
• One AC power cable (USA type)
Note.
Other IEC cords are available separately.
• One DC power connector (field installable)
• One weatherized Ethernet RJ-45 connector (field installable)
• One Ethernet cable (shielded Cat5e)
• Quick start sheet
• Warranty card
Parts of an edge node
The next picture shows the HotPort 5020-E node. The LEDs are visible at the top
of the node when it is oriented correctly for installation on a pole.
Radio 1 and Radio 2 LED Power LED
1
Radio 1
(11agn)
2
3
Pressure relief valve Ethernet
port D/C port
The next picture shows the connectors, reset cover screw, and ground screw on
the bottom panel of a HotPort 5020-E node. Weatherproof caps protect the
connectors on the bottom panel. Rubber caps are on the antenna connectors;
they are not weatherproof.
Caution!
Do not use the rubber caps outdoors. You must use
weatherproof caps or weatherproof antenna connections to all
antenna connectors. Damage from incorrect deployment is not
covered by the product warranty.
!