Firetide HotPort 5020, Installation Manual

Page: 13 / 47

5
Before you permanently install
Before you install a node in a permanent location, you need to make sure you
have all of the correct components and make sure the components are
operational.
Preparing what you need to install
To get what you need to set up a node:
1.
Open the box.
2. Remove the contents.
3. Check the contents for damage.
If a part is missing or damaged, call your Firetide reseller.
4. If the contents are good and correct, keep the box for future use.
Box contents for a HotPort 5020-E node
The HotPort 5020-E node box contains these items:
•
HotPort edge node in a NEMA-4X enclosure and an assembled mount bracket
• One 3 dBi omni-directional staging antenna
Caution.
Do not use staging antennas outdoors. The staging antennas
are rated for indoor use only and are recommended for pre-
configuration purposes only. If you use the staging antennas
outdoors, they can be damaged. Damage from incorrect deployment is
not covered by the product warranty.
• One reverse-polarity SMA to type N plug adapter
• Mount kit
- U-bolts, M6x1.0-80mm, with flat washers, split washers, nuts
- Claw-tooth pole grippers
- M6x1.0-40mm hex bolt
- M6x1.0-20mm hex bolt
- Hex-head socket wrench
• One PoE+ injector
!