Hardware Installation Guide
22
Metal Straps on Universal Mounting Bracket
Pole Mounting
You can mount the HotPort 3203 to a pole using U bolts. The section below describes how to
mount the enclosure to a 1.5” to 2” (3.8 cm to 5 cm) pole.
Using U Bolts
1. Position the pole mounting bracket against the pole. Insert the U bolts from behind the
pole and through the pole mounting bracket.
2. Insert the two U bolts through the four holes near the top and bottom of the universal
mounting bracket. (Note: If mounting to a pole with a diameter less than 2”, on each U
bolt threaded shaft, place a washer, a lock washer, and one or more 6 mm nuts as
spacers.)
3. Use four lock washers and 6 mm nuts to secure the universal mounting bracket, pole
mounting bracket, and U bolts assembly.
4. Attach the enclosure to the universal mounting bracket by sliding the metal clips on the
back of the enclosure into the metal straps on the universal mounting bracket.
5. Secure the enclosure to the universal mounting bracket using the four captive screws on
the sides of the universal mounting bracket.
Metal straps
