Firegear KWBH-2, Owners & Installation Manual, Page: 16 / 40

16
Firegear Outdoors® Key West™ Series
INSTALLATION
13 . Secure regulator in position with top bracket - secure with 2 screws.
NOTE: Top bracket to sit over top of lower bracket.
Attach supplied "MAX. 0.5 PSI" sticker to top bracket.
Regulator
Flexline
Regulator
Bracket
Inlet pressure tap
Top
Bracket
12 . Install regulator bracket onto unit base with 2 screws. Connect fl ex
line to regulator—position regulator onto bracket.
Diagram 13
Diagram 14
14. Remove connector from end of fl ex line.
Remove
connector
Diagram 15
16 . Attach the label "this unit has been converted to NG" near on top of
the serial # decal.
17 . Replace red "LPG" label with yellow "NG" label.
18 . Bring gas to appliance. The connector removed in previous steps
can be used on the inlet side of the regulator.
19 . Check all gas connections (at valve, regulator, and NG outlet) under
normal operating pressure, for leaks, with soapy water.
NOTE : If soap bubbles, this would indicate a gas leak.
20. Check inlet and outlet pressures.
21 . Reinstall panels.
15 . Connect fl ex line to valve fi tting.
Connect fl ex line
to valve
Diagram 16