T- Burner Kit
REV. A Page 8
Before you begin installing the T-Burner into a burner pan ensure the center hole is 7/8” to 1-inch in diameter (See Fig. 6).
Ensure to seal the burner nipple and each NPT fitting with thread tape or pipe compound.
NOTE:
Flared fittings
will not require tape or compound on the flared side.
Step 1:
Install the T-Burner through the pan (See Fig. 4) then install the OAS and U3-8D-S to the nipple connect inlet gas
line as shown in Fig. 5.
7/8” to 1- Inch Center Hole
Fig. 3
Minimum center clearance hole in burner pan.
ALL T-BURNER MODELS
T-Burner ASSEMBLY
CAUTION:
Do not assemble the OAS and U3-8D-S until you are ready to install the T-Burner into the burner pan. The
OAS is 1½” in diameter and would not fit the recommended center hole size per Fig. 6 and Fig. 9.
GAS FL
OW
T-Burner Side View
Burner Pan
U3-8D-S
OAS (Orifice)
Burner Nipple
Fig. 4
T-Burner Installed into Burner pan/disc.
