REV. A Page 2
T- Burner Kit
REV. A Page 3
Specifications
4
Preparation for Non-Combustible Structure
5
High Elevation
5
Cross Ventilation Requirements
5
Pipe Sizing Chart
6
Installation into an Approved Enclosure
7
H-Burner Assembly
8
Installing Key Valve / Media
9
Typical Installation Drawings
10
Operation
11
Lighting Instructions
11
Replacement Parts
12
Replacement Parts List
13
Converting to LP Gas
14
Optional Accessories
15
Fire Pit Maintenance
15
Trouble Shooting
15
TABLE OF CONTENTS
All media (i.e. lava rock, lava stones, lava boulders and fire glass) has the potential of
thermal spalling. This is a process that may occur when media is wet and moisture gets
trapped inside of the material due to rapid temperature differences. When this happens
the media has the potential to crack or “pop” outside the fire feature.
WE HIGHLY RECOMMEND COVERING ALL FIRE FEATURES WHEN NOT IN USE
The use of a cover can lessen the impact of thermal spalling; however, heavy rains, high
humidity and the presence of moisture may still cause the media to pop.
ALWAYS USE CAUTION WHEN USING THE FIRE FEATURE
Extra caution should be taken when lighting a fire feature when heavy rains, high humidity
and moisture are present. Light the fire feature; leave the area allowing any moisture in
the media to dissipate. We strongly recommend that during this drying out time that you
monitor the fire feature from a distance. This drying out period should be no less than 30
minutes. Continue monitoring the flame from distance to ensure that all popping has
ceased before fully enjoying the fire.
CAUTION
CALIFORNIA PROPOSITION 65
WARNING
This product can expose you to Chromium, which is
known to the state of California to cause cancer
and birth defects or other reproductive harm.
(For more information, go to www.p65warnings.ca.gov)
