13 |
P a g e
Use with a Legacy Intercom – WB505L
(30XXR, 110, and 210 Intercoms)
The Wireless Base Station is designed to integrate into older Legacy Firecom
Intercom systems. This lets the user operate two-way-radios with a Wireless
Headset. When used in Legacy Intercom mode, the Wireless Base Station must
have Ports 1 and 6 connected to the Firecom Intercom. This allows Intercom
Only headsets to hear the communications of a headset utilizing radio transmit.
Only one channel is available in Legacy Intercom Mode.
Setting up Legacy Intercom Mode (WB505L default)
1.
Unplug the Base Station, then plug it back in while holding the Pairing
buttons for positions 2 and 3 until the green channel indicator LEDs for
positions 2 and 3 light up (about 5 seconds).
2.
The Base Station is now in Legacy Intercom mode.
3.
Unplug the Base Station, then plug it back in. The Base Station is now ready
to use. In this mode, the position a Headset is paired to does not impact
its operation.
Intercom Connections
1.
In this mode port 6 must be connected to a Firecom Intercom using the
supplied flat cable.
2.
Pair the Headset(s) to the Base Station. For Radio Transmit operation,
make sure your Headset is a radio transmit model and that it is configured
to transmit radio over DECT. Consult your Headset manual for
instructions.
If Radio Transmit operation is required, connect port 1 to the Firecom
intercom using the correct type flat cable. The Firecom intercom must be
connected to a two-way-radio.
Operation
All non-radio transmit audio is through Port 6 of the Base Station. When a
Radio Transmit headset initiates a transmission by activating its PTT button, its
audio is switched to Port 1 along with the PTT signal.
