22
d = day
number of coffees made
u = week
number of coffees made
L = life
number of coffees made
ADJUSTMENT OF THE MEASURE
OF GROUND COFFEE
To adjust the grinding time, keep pressing
C2
and
M
till you hear three bleeps followed by the “1CAP” dis-
play, press
C2
to display the seconds per cup. Increase
or decrease the time with C1 and
M
, confirm with
C2
.
After saving, “2CAP” will be displayed, press
C2
to dis-
play the seconds for 2 cups. Increase or decrease the
time with
C1
and
M
, confirm with
C2
.
STATS DISPLAY AND M DEACTIVATION
To activate or deactivate the statistics, keep
C1
pressed till
you hear six bleeps, when “STATS” will be displayed; press
C1
to display the status, with
M
and
C2
the stats display
is activated (ON) or deactivated (OFF), confirm with
C1
.
After ”MAn” will be displayed (this function activates or
deactivates the continuous grinding button M), press
C1
to display the status, with
M
and
C2
the stats display is
activated (ON) or deactivated (OFF), confirm with
C1
.
TIME AND WEEK ADJUSTMENT
To adjust the time, press
C1
and
M
simultaneously till you
hear two bleeps and the hour starts flashing; press
M
to
increase and confirm with
C1
, then the seconds start flashing,
press
M
to increase and confirm with
C1
. At this point ds= will
appear: to select the day go to the number corresponding to
the day (from one to seven) and confirm pressing
C1
. Finally
11=1 will appear: press 1 if you wish to enable continuous
grinding, 0 if you wish to disable it. Confirm by pressing
C1
.
Warnings for operation
·
The appliance must not be left switched on if there
is no coffee in the hopper.
·
For coffee grinder-dosers, the doser lever must always be
pulled down as far as possible: never pull it only partly.
·
For coffee grinders, make sure that the coffee out-
let is free from any obstruction otherwise the appli-
ance will stop. To empty out all the ground coffee,
firmly pull the outlet handle. Use adequately sized
bags to collect the ground coffee so that the entire
amount of coffee coming out can be collected.
Safety devices
THERMAL CUT-OUT
The electric power supply of the motor is automatical-
ly interrupted by a thermal cut-out if overheating
occurs. Interruption of the power supply of the motor
can be caused when the grinding blades are blocked.
In this case, it is necessary to switch off the appliance
and disconnect it from the electric power supply.
Contact the technical assistance service. If the appli-
ance gets blocked, never try to release it manually, as
it could start up again unexpectedly. If the blocked
motor is caused by overheating, it is necessary to wait
until it has cooled down before taking any action.
SAFETY SCREWS
·
The safety screw that fastens the hopper to the grind-
ing blade holder must never be removed by the user.
·
The grinding adjustment ring nut must not be
removed, as this would make its dangerous rotat-
ing parts accessible. It can be blocked, thanks to an
anti-unscrewing device on the ring nut comprising
a screw positioned in one of the two holes in the
ring nut, which enables the user to adjust grinding
as required. This screw must never be removed.
COFFEE OUTLET SAFETY DEVICE
The user must never remove the coffee outlet safety
device from the doser unit. The coffee outlet safety device
may only be removed by specialized personnel and only
when the electric power supply cable has been previous-
Summary of Contents for F4 E Nano
Page 2: ......