EN
9
suction button on the handle of the suction hose is
pressed.
At regular intervals, fill the tank on the suction
hose support with water.
5.5 Cleaning the Filter
When there is a decrease in suction power,
clean or replace the filter.
Open the filter door on the rear of the suction
head.
Remove the filter and clean it with compressed air
and by shaking it or replace it if the filtered
material is excessively dirty.
5.6 Stopping
The machine can be stopped by releasing the
steering column and causing it to go to the locked
position.
The engine continues to run.
Turning ignition key to OFF and removing
it also stops the engine.
If the appliance is not used for a long period of
time, proceed as follows:
-
Place the appliance on a level surface.
-
Lock the drive by releasing the steering column.
-
Fill the fuel tank and close the petrol cock.
-
Change the motor oil.
-
Turn the ignition key to OFF and remove it.
-
Unscrew the spark plug and put about 3
cc of oil in the spark plug housing bore.
Rev up the engine a few times without the
spark plug. Screw on the spark plug.
-
Clean the unit inside and outside.
-
Store it in a sheltered and dry place.
-
Disconnect the battery.
-
Charge the battery every 2 months or so.
5.7 Transport
6 Care and Maintenance
6.1 General Warnings
Before cleaning and servicing the appliance or
replacing components, turn it off and remove the
ignition key.
WARNING
If none of the previous actions stops the
machine, press the red emergency
button on the dashboard.
HAZARD
Respect the weight of the appliance
during transport.
HAZARD
For transport on vehicles secure the
appliance according to directives in
force so that it cannot slip or tip over.
Ensure the immobility of the appliance by
locking it with belts and ropes.
The ropes must pass through the tubes of
the machine frame protruding at its
bottom.
Secure the wheels with wedges.
The appliance cannot be lifted by belts.
Use a ramp to load and unload the
appliance, using its own drive.
WARNING
HAZARD
HAZARD
