Fine offset WH32M, User Manual

Page: 22 / 24

Version 2.0 Page
22
Problem Solution
Make sure the remote sensor LCD display is working on
both the console and the remote sensor.
Install a fresh set of batteries in the remote
thermo-hygrometer. For cold weather environments,
install lithium batteries.
Make sure the remote sensors are not transmitting
through solid metal (acts as an RF shield), or earth
barrier (down a hill).
Move the display console around electrical noise
generating devices, such as computers, TVs and other
wireless transmitters or receivers.
Move the remote sensor to a higher location. Move the
remote sensor to a closer location.
Temperature sensor reads too high in the
day time. Make sure the thermo-hygrometer is mounted in a
shaded area. The pre preferred location is a north facing
wall because it is in the shade most of the day.
Indoor and Outdoor Temperature do not
agree Allow up to one hour for the sensors to stabilize due to
signal filtering. The indoor and outdoor temperature
sensors should agree within 3.6 °F (the sensor accuracy
is ± 1.8 °F).
Use the calibration feature to match the indoor and
outdoor temperature to a known source.
Indoor and Outdoor Humidity do not
agree Allow up to one hour for the sensors to stabilize due to
signal filtering. The indoor and outdoor humidity sensors
should agree within 10 % (the sensor accuracy is ± 5 %).
Use the calibration feature to match the indoor and
outdoor humidity to a known source.
Display console contrast is weak Plug into AC power. The console was not designed to run
exclusively on batteries.
8 Liability Disclaimer
Please help in the preservation of the environment and return used batteries to an authorized depot.
The electrical and electronic wastes contain hazardous substances. Disposal of electronic waste in
wild country and/or in unauthorized grounds strongly damages the environment.