EN
44
5.6 Connection of the communication and digital signals
The communication and control signals cables must be connected to the dedicated connectors placed on the bottom side of the inverter:
- Digital input and RS485 connector
(12)
.
- Ethernet 1/2 connectors
(11)
.
- USB connector for accessories board
(10)
.
Before being connected, the cables must be passed through the cable glands of the signals connection box
(08)
:
- Digital input and RS485 cable gland
(20)
.
This M20 cable gland is equipped with protection cap and can accept 5...10 mm cable diameter.
An accessory 2x5mm holes gasket is supplied; each hole can accept a cable with a diameter of 5mm.
- Ethernet 1/2 cable gland
(21)
.
This M25 cable gland is equipped with protection cap and can accept 10...17 mm cable diameter.
Two accessory gasket are supplied; 3x6mm and 3x7mm holes gasket.
12
10
11
08
20
21
6 mm
0.236”
3x
5 mm
0.196”
2x
7 mm
0.275”
3x
5...10 mm
0.196...0.393”
1x
10...17 mm
0.393...0.669”
1x
6 mm
0.236”
3x
5 mm
0.196”
2x
7 mm
0.275”
3x
5...10 mm
0.196...0.393”
1x
10...17 mm
0.393...0.669”
1x
21
20
