CODE
QTY
WIDTH
[cm]
LENGTH
[cm]
NOTES
453208
1
34
16
RED ABRASIVE PAD
453410
1
34
16
BROWN ABRASIVE PAD
453411
1
34
16
WHITE ABRASIVE PAD
453412
1
35
16
MICROFIBRE PAD
TROUBLESHOOTING
This chapter lists the most common problems linked with the use of the machine. If you are unable to resolve the problems with the information
given here, please contact your nearest assistance center.
PROBLEM
POSSIBLE CAUSE
SOLUTION
THE MACHINE
DOES NOT START
The main switch is OFF.
Check that the main switch is on; if not, press it.
An alarm sequence appears on the control display when
it is switched on.
Stop the machine immediately, and contact a specialized
service center.
The battery is not correctly inserted into the machine.
Insert the battery correctly, see “INSERTING THE
BATTERY INTO THE MACHINE” on page 15
The battery charge level is low.
If the battery charge level is critical, carry out a full
charging cycle. See “RECHARGING THE BATTERY” on
THE BATTERY IS
NOT PROPERLY
FITTED
The charger cable connector is not correctly plugged into
the socket on the base of the battery charger.
Try reconnecting the charger cable connector to the
socket on the base of the battery charger.
The battery charger power cable plug is not properly
plugged into the mains socket.
Connect the battery charger power cable plug to the
mains socket.
The characteristics of the power supply network do not
correspond with those required by the battery charger.
Check that the electrical characteristics on the battery
charger plate are the same as those of the mains supply
system.
The LEDs of the battery charger blink repeatedly.
Referring to the use and maintenance manual for the
battery charger, check what the flashing lights on the
charger during battery charging mean.
THE MACHINE
HAS A VERY LOW
WORK AUTONOMY
Check the battery charge level; check the symbol on the
control display.
If the battery charge level is critical, carry out a full
charging cycle. See. “RECHARGING THE BATTERY” on
THE AMOUNT
OF DETERGENT
SOLUTION ON
THE BRUSH
HEAD BODY IS
INADEQUATE
The quantity of detergent solution present in the solution
tank is not suitable for the type of work to be carried out.
Fill the solution tank; see “FILLING THE SOLUTION
The nozzles on the brush head body are blocked.
Clean the nozzles and the entire machine water system;
see “ROUTINE MAINTENANCE” on page 18
THE MACHINE
DOES NOT CLEAN
CORRECTLY
The machine does not start.
Read the section “THE MACHINE DOES NOT START”.
Not enough detergent solution comes out.
See the section "THE AMOUNT OF DETERGENT
SOLUTION ON THE BRUSH HEAD BODY IS
INADEQUATE".
The pad has not been correctly inserted into the machine. Position the pad correctly.
The type of pad in use is not suitable for the dirt to be
tackled.
Check that the pad selected is suitable for the work to
be carried out; for help, contact the nearest technical
assistance center.
The pad is excessively worn.
Check the state of wear of the brush and, if necessary,
replace it.
EXCESSIVE FOAM
PRODUCTION
The detergent being used is not suitable.
Check that a low foam detergent has been used.
The floor is not very dirty.
Dilute the detergent more.
20