ADDITIONAL FUNCTIONS
ECO MODE
At the centre of the control panel is the ECO MODE button; pressing this will activate “ECO MODE”, a program which guarantees the best
possible performance in terms of consumption and cleaning.
To activate the ECO MODE program with the machine stopped and active, press the button (1) in the centre of the control panel (
Fig.1
).
N.B.:
As soon as the button (1) is pressed, “ECO” will appear on the control display (
Fig.2
).
N.B.:
As soon as the machine is activated by pressing the button (2) located on the control panel (
Fig.1
), ECO MODE will be
automatically loaded.
N.B.:
To deactivate ECO MODE, press the button (1) in the centre of the control panel (
Fig.1
). As soon as the button (1) is pressed,
“ECO” will disappear from the control display (
Fig.3
).
N.B.:
ECO MODE can also be deactivated by pressing one of the buttons (3) (
Fig.1
) used to adjust the supply of detergent solution to the
brush (see paragraph “ADJUSTMENT OF THE DETERGENT SOLUTION FLOW” on page 19).
N.B.:
ECO MODE can also be deactivated by pressing the “SILENT/MAX” button (4) (
Fig.1
), which is used to adjust the suction motor
performance (see paragraph “SILENT-MAX FUNCTION” on page 19).
MANUAL MODE
To change from “ECO MODE” to “MANUAL MODE”, simply change one of the following parameters:
1. Adjust the quantity of detergent solution present in the machine water system using the buttons (3) on the control panel (
Fig.1
) (see
paragraph “ADJUSTMENT OF THE DETERGENT SOLUTION FLOW” on page 19).
2. Adjust the performance level of the suction motor by using the button (4) on the control panel (
Fig.1
N.B.:
When “MANUAL MODE” is active in the control display, “ECO” will disappear from the control display (
Fig.2
).
N.B.:
The first time one of the two symbols shown above in the control display are pressed, the current level of detergent solution will be
shown for two seconds (
Fig.7
).
5. Lower the squeegee, activate the pedal (3) located at the rear right of the machine (
Fig.4
).
6. Activate the suction motor by pressing the button (4) located on the control panel (
Fig.3
).
N.B.:
As soon as the button (4) is pressed, “ON” will appear on the control display (
Fig.5
).
7. Press the operator presence lever (5) (
Fig.5
).
8. As soon as the operator presence levers are pressed, the brush head motor and the suction motor will start working, the pump in the water
system will not start to deliver detergent solution to the brush. During the first few metres of work, check that the squeegee is frying properly.
9.
The machine will now work at its maximum efficiency level.
ATTENTION: The drying without scrubbing operation should only be carried out if the device was used
beforehand to carry out a scrubbing without drying operation.
18
1
ECO
2
ALL_90
7
LO
4
H2o 1
3
Hi
5
1
4
2
3
