www.itmfilters.com
The joint hydraulic action of the turbine and the hydraulic cylinder guarantees the sweeping of
the nozzles throughout the filter cartridge.
The pressure difference that occurs between the cleaning chamber (chamber where the turbine
is located) and the filtration chamber must not exceed 2,5 kg/cm². This pressure difference is
read during the cleaning process, by subtracting between the two filter pressure gauges.
A higher pressure difference can lead to deterioration of the filter cartridge. To regulate the
pressure difference, the cleaning valve must be adjusted.
The technology used in the manufacture of the HYDRAULIC-200-H filter offers high filtration
surfaces with compact lengths, due to the maximization of the filter cartridge.
6.
Maintenance and spare parts
6.1
Maintenance
Board check.
Repaint.
Battery check (if applicable).
The filter mesh requires periodic manual cleaning, for this:
1.
Disconnect the power supply and the water supply.
2.
Open the drain cock in the “CLOSE” position and wait for the filter to drain.
3.
Loosen the screws on the cover of the filtered water outlet area.
4.
Remove the filter cartridge and clean it with water on the outside and a cedar brush
on the inside.
5.
Insert the mesh cartridge and close the lid making sure it is tight.
Cleaning chamber
Clean water chamber
Filter chamber
Raw water chamber
U
SER
M
ANUAL
HYDRAULIC-200-H
7
I
MAGE
5
