FIK-UV-IR-HD
User Manual
Doc. No. 06-935.02
For more information & Technical support: (800)-979-FIKE (3453)
6
To install the tilt mount:
a)
Place the tilt mount (Fig. 1) in its designated location and secure it with four screws through four
0.28" (7mm) diameter holes. There are four captive screws with spring washers in the tilt mount.
The following drawing shows the location of the four holes for the screws and washers.
Figure 1- Tile Mount Base - Rear View
The following drawing is a side view of the tilt mount:
Figure 2- Tile Mount Base - Side View
2.6
Installing the detector
Use the following steps to connect the detector to the tilt mount, referring to Figure 3:
a)
Unpack the detector
Summary of Contents for FIK-UV-IR-F-HD Series
Page 2: ......
