Fiery E-750, Configuration Manual, Page: 75 / 184

4
4-19 Network Setup options
Add Filter
IP Filter Type
IP Address/IP Range [IP Address]
Select IP Address to permit or reject individual IP addresses. Select IP Range to specify
a range of IP addresses to be permitted or rejected. Up to 16 IP addresses can
be specified.
N
OTE
:
Do not enter “0.0.0.0” or “255.255.255.255”.
Delete Filter
Yes/No [No]
This option allows you to delete IP addresses individually or by range.
Edit Filter
Yes/No [No]
This option allows you to make changes to IP addresses or a range of IP addresses to be
permitted or rejected.
If you selected Yes to enable IP filtering, these options appear. Add, delete, and edit
filters as required. To add filters, enter the IP address, IP range, and accept the
filter policy.
IP Port Setup
All ports not listed in the following setup options are closed. Supported protocols are
listed in parenthesis after the port number.
Configure IP Ports
Yes/No [Yes]
Select Yes to proceed to the subsequent IP Port settings.
80 (HTTP)
Enabled/Disabled [Enabled]
Select Enable to enable the 80 (HTTP) port. (Fiery WebTools and IPP printing)
137-139 (NetBIOS)
Enabled/Disabled [Enabled]
Select Enable to enable the 137-139 (NetBIOS) ports. (SMB printing)