Fiery E-750, Configuration Manual, Page: 149 / 184

6
6-3 Setting up WebTools
T
O SET UP
W
EB
T
OOLS ON THE
E-750
1. In E-750 Network Setup, enable TCP/IP.
2. Set a valid, unique IP address for the E-750, and then set the subnet mask.
Set a gateway address, if required.
3. Enable Web Services.
4. In E-750 Printer Setup, confirm that the Print Queue is published.
T
O SET UP
W
EB
T
OOLS ON A COMPUTER
1. Enable TCP/IP networking.
2. Assign the workstation a valid, unique IP address and subnet mask, and a gateway
address, if required.
3. Install an Internet browser that supports the Java language and frames.
Make sure Java is enabled. For more information on supported browsers and
WebTools requirements, see the
User Software Installation Guide .
T
O ACCESS
W
EB
T
OOLS
1. Start your Internet browser.
2. Enter the IP address or DNS name of the E-750.
3. Press Enter.
The E-750 home page appears.
4. Click the name of a particular WebTool.
5. Click Configure to enable specific WebTools for users.
Setting up WebTools
In order for network users to access and use WebTools, you must set certain E-750
options in Network Setup and Printer Setup. You also must prepare each user’s
workstation to communicate with the E-750 over the Internet or intranet.