S
ERVICE
P
ROCEDURES
73
Transferring options to the new motherboard
After you verify that the new motherboard solves the problem that you are troubleshooting,
you must use the Fiery Options Utility and the one-time use dongle to transfer options to the
new motherboard.
T
O
TRANSFER
OPTIONS
TO
THE
NEW
MOTHERBOARD
N
OTE
:
This procedure assumes that the E-41 is fully assembled, verified in Service Mode (see
), and powered off.
1. Make sure that the one-time use dongle is firmly attached to a USB port on the E-41 and that
no other dongles or USB storage devices (for example, a flash or thumb drive) are attached to
the E-41.
The options transfer process may fail if other dongles and/or USB storage devices are
connected to the E-41 during the process.
2. Power on the E-41.
3. Immediately insert the Fiery Options Utility into the DVD drive.
N
OTE
:
The Fiery Options Utility must be in the DVD drive in time for the E-41 to boot from
it. If the E-41 does not boot from the Fiery Options Utility, allow the E-41 to start up, eject
the CD, turn off the E-41, and then repeat steps 2 and 3.
N
OTE
:
If an error message displays, see
4. To continue, choose the Control Panel or monitor (if present) as the interface to use
throughout the option transfer process.
The first screen that displays when you start the Fiery Options Utility allows you to choose
the interface that you will use throughout the procedure. Choose an interface by selecting OK
on the Control Panel or monitor. The interface not chosen is then disabled during the option
transfer process.
Control Panel
Monitor
Press OK to
continue
Options Utility
OK
Fiery Options Utility
To cont
i
nue runn
i
ng the F
i
ery
Opt
i
ons Ut
i
l
i
ty us
i
ng the mon
i
tor,
keybo
a
rd
a
nd mouse, press Enter
or cl
i
ck OK. To cont
i
nue runn
i
ng
the F
i
ery Opt
i
ons Ut
i
l
i
ty us
i
ng the
F
i
ery Control P
a
nel
i
nste
a
d, press
OK on the F
i
ery Control P
a
nel.
OK
Summary of Contents for E-41
Page 156: ......
