4-47
4
Print Controller X4(AR-PE1) system software service
5.
When the following screen is displayed, make sure “Yes” is displayed and then select
OK. The restore backup process will begin immediately.
Wait while the Print Controller X4(AR-PE1) Control Panel displays screens that indicate
that the software is being restored. After the system software is restored, the
Print Controller X4(AR-PE1) will run diagnostics. Once the system is restored, the Idle
screen is displayed.
6.
Configure Setup using the Configuration page you printed earlier.
Bypass settings not included on the Configuration page if it is more appropriate for the
network administrator to set them. See the
Configuration Guide
for more information.
7.
Reinstall fonts, Command WorkStation software, or custom simulations that may have
been deleted due to system software restoration.
Installing system software from a CD
The Print Controller X4(AR-PE1) System Software CD includes the system software
and fonts. Use the System Software CD when:
• You replace the Print Controller X4(AR-PE1) HDD
• You upgrade to a more recent version of the system software
• Restore Backup fails
T
O
INSTALL
P
RINT
C
ONTROLLER
X4(AR-PE1)
SYSTEM
SOFTWARE
1.
If you have not done so already, print the following from the Functions menu (if
possible):
• Configuration page —records the customer’s current Setup configuration
The Setup configuration will be reset to the default configuration when system
software is installed.
• Font List— the Font List detail the fonts that are resident on the
Print Controller X4(AR-PE1) HDD. Along with the fonts provided, the customer
may have installed additional fonts that will be deleted when system software is
installed.
All data will be
deleted. Continue?
Yes
OK
Restore Backup
Select
