4-27
4
Motherboard
T
O
REPLACE
A
DIMM
1.
To release a DIMM, push outward on the levers on each side of the DIMM
(see Figure 4-16.)
F
IGURE
4-16
Releasing a DIMM
2.
Slide the DIMM straight out of the socket.
3.
To replace a DIMM, slide it straight into the socket until the levers on each side lock into
place.
Make sure that the levers close securely around the ends of the DIMM and that each
DIMM is fully seated in its socket.
N
OTE
:
DIMMs fit the socket only one way. The two notches on the bottom of each
DIMM should line up with the notches in the socket.
4.
Reassemble the Print Controller X4(AR-PE1) and verify its functionality (see “Restoring
Print Controller X4(AR-PE1) functionality after service” on page 4-11).
Lever
Lever
DIMM
Socket notches
