3-4
3
Connecting the Print Controller X4(AR-PE1)
Verifying the connection
After you connect the Print Controller X4(AR-PE1) to the copier, print the Test Page to
verify that the connection between the Print Controller X4(AR-PE1) and the copier is
good.
Printing the Print Controller X4(AR-PE1) Test Page
Before connecting the Print Controller X4(AR-PE1) to the network, print the Test Page
to verify that the Print Controller X4(AR-PE1) is connected properly to the copier. The
Test Page is a color file that resides on the Print Controller X4(AR-PE1) hard disk drive.
T
O
A
T
EST
P
AGE
FROM
THE
C
ONTROL
P
ANEL
1.
Power on the copier and allow it to warm up.
2.
Power on the Print Controller X4(AR-PE1) from the power switch on the back panel.
Messages appear on the Control Panel as the Print Controller X4(AR-PE1) runs through
its startup diagnostics.
3.
Before proceeding, make sure that the copier is not in use. The
Print Controller X4(AR-PE1) Info screen should read Idle.
4.
At the Idle screen, press the menu button once (see “Using the Control Panel” on
page 3-8). The Functions menu is shown below:
Print Pages
Suspend Printing
Resume Printing
Shut Down
Functions
Clear Server
Run Setup
Run Diagnostics
Calibration
Functions
Use the up and down buttons to
scroll through these options. Use
the line selection buttons to the
right to select Print Pages.
