3
Preliminary checkout
3-1
Once you have unpacked or serviced the Print Controller X4(AR-PE1), power it up
before you connect it to the copier and the network. Diagnostics are run automatically
during startup to check the Print Controller X4(AR-PE1) for internal problems.
Preliminary checkout
The following procedure describes how to connect power to the
Print Controller X4(AR-PE1).
T
O
CONNECT
POWER
AND
START
THE
P
RINT
C
ONTROLLER
X4(AR-PE1)
1.
Make sure the Print Controller X4(AR-PE1) power switch is in the off position (press 0),
and then connect the other end of the Print Controller X4(AR-PE1) power cable to a wall
outlet.
F
IGURE
3-1
Print Controller X4(AR-PE1) power
2.
Power on the Print Controller X4(AR-PE1) using the switch at the back of the
Print Controller X4(AR-PE1). The power supply automatically senses the correct voltage.
3.
To confirm that the Print Controller X4(AR-PE1) is operating properly allow
Print Controller X4(AR-PE1) startup to proceed without interruption while you watch the
Control Panel. Do not press any buttons on the Control Panel.
Chapter 3:
Connecting the
Print Controller
X4(AR-PE1)
Power switch
Power connector
