2-3
2
Checking the customer site
Checking the customer site
Before you install the Print Controller X4(AR-PE1), check site conditions and inform
the customer of any installation requirements.
Copier model
❑
What copier model is installed?
❑
Is there space near the copier for the Print Controller X4(AR-PE1)?
Make sure that there is space for the Print Controller X4(AR-PE1). You may need to
move the copier out from the wall for easier access to the connectors.
❑
Does the copier require service or adjustments?
Copy the copier color test page before you install the Print Controller X4(AR-PE1).
If the copied image indicates that the copier needs adjustment, inform the customer.
After getting approval, complete the copier service needed.
Power
❑
Is there a dedicated grounded electrical outlet near the copier for the
Print Controller X4(AR-PE1)?
Locate the grounded electrical outlet that will supply power to the
Print Controller X4(AR-PE1). You should not run the Print Controller X4(AR-PE1) and
the copier on the same circuit. Use a surge suppressor for the
Print Controller X4(AR-PE1).
•
Do not
use a 3-prong adapter in a 2-hole ungrounded outlet.
•
Do not
use an extension cord.
•
Do not
plug the Print Controller X4(AR-PE1) into a circuit with heating or
refrigeration equipment (including water coolers).
•
Do not
plug the Print Controller X4(AR-PE1) into a switchable wall outlet. This can
result in the Print Controller X4(AR-PE1) being turned off accidentally.
