vii
Precautions
Precautions
Always observe the following general precautions when installing and servicing the
Print Controller X4(AR-PE1):
1.
Report any shipping damage.
If there is any evidence of shipping or handling damage to the
Print Controller X4(AR-PE1) packing boxes or their contents, save the damaged boxes
and parts, call the shipper immediately to file a claim, and notify your authorized
service/support center.
2.
Never alter an existing network without permission.
The Print Controller X4(AR-PE1) will probably be connected to an existing Local Area
Network (LAN) based on Ethernet or Token Ring hardware. The network is the link
between the customer’s computer, existing laser printers, and other prepress equipment.
Never disturb the LAN by breaking or making a network connection, altering
termination, installing or removing networking hardware or software, or shutting down
networked devices without the knowledge and express permission of the system or
network administrator or the shop supervisor.
3.
Never enter an IP address in Print Controller X4(AR-PE1) Network Setup.
Only the network administrator should enter an IP address on a network device.
Assigning the Print Controller X4(AR-PE1) an incorrect IP address may cause
unpredictable errors on any or all devices connected to the network.
4.
Handle the Print Controller X4(AR-PE1) Control Panel display window with care.
The Print Controller X4(AR-PE1) display window is made of glass. If the glass breaks
and the liquid crystal inside leaks out, avoid contact with it. If you do come in contact
with the liquid crystal, wash it off with soap and water immediately.
5.
Avoid pressing the surface of the display window.
Applying pressure to the display window will cause it to change color.
6.
Use a soft cloth moistened with isopropyl or ethyl alcohol to clean the surface of the
Print Controller X4(AR-PE1) display window.
Other solvents, such as water, may damage the polarizer on the display window.
