5-10
5
Troubleshooting
N
OTE
:
Some beep codes continue to loop until the Print Controller X4(AR-PE1) is
powered off and the error is corrected.
T
ABLE
5-1
Print Controller X4(AR-PE1) beep codes
Beep code
Area reporting
the error
Suggested action
1 long beep—pause—2 short beeps
Battery
• Replace the battery on the motherboard.
• Make sure you reset the time and date in Setup after replacing
the battery.
5 short beeps—pause—1 long beep
DIMMs
• Make sure all DIMMs installed on the motherboard are
Electronics For Imaging approved.
• Reseat all DIMMs in their sockets and restart the
Print Controller X4(AR-PE1) in order to run the startup
diagnostics.
• If the error persists, replace each DIMM one at a time with a
good DIMM until you locate the faulty DIMM(s).
• If the above does not correct the error, you may need to
replace the motherboard.
6 short beeps—pause—1 long beep
8 short beeps—pause—1 long beep
CMOS settings
• Reboot the Print Controller X4(AR-PE1).
• If the problem persists, replace the battery on the
motherboard.
• If the problem still persists, you may need to replace the
motherboard.
N
OTE
:
If you replace the battery, reset the time and date in Setup
after replacing the battery.
9 short beeps—pause—1 long beep
DIMMs
• Make sure all DIMMs installed on the motherboard are
Electronics For Imaging approved.
• Reseat all DIMMs in their sockets and restart the
Print Controller X4(AR-PE1) in order to run the startup
diagnostics.
• If the error persists, replace each DIMM one at a time with a
good DIMM until you locate the faulty DIMM(s).
• If the above does not correct the error, you may need to
replace the motherboard.
10 short beeps—pause—1 long beep
11 short beeps—pause—1 long beep
