Fieldmann FZP 56516-B, Manual

Page: 22 / 37

EN 22
FZP 56516-B
Cleaning and maintenance
Log above the ground
In part “A” make a cut from below to a third of the
log and then complete the cut from above. In part
“B” make a cut from above to a third of the log
and then complete the cut from below.
Removing a fallen tree
First fi nd out to which side the branch is bent. Then
make the initial cut from the side of the bend and
then complete the cut from the opposite side.
ATTENTION! A bent branch may spring up.
9. CLEANING AND MAINTENANCE
ATTENTION! Prior to cleaning, inspecting or repairing the chain saw, its engine must be turned off and
cold and the spark plug must be removed to prevent accidentally starting the engine.
Maintenance after every use
Remove the guide bar and use a brush to clean away accumulated sawdust from the entire chain saw. Use
a spatula or screwdriver to remove stubborn dirt.
Air fi lter:
Loosen the screw (Fig 1, point 11) and remove the air fi lter cover. Take out the fi lter insert and use a brush to
remove the dust. If the fi lter insert is clogged with dust, dismantle into 2 parts and wash it out in petrol. If you
are using compressed air, blow from the inside out.
Lubricating hole:
Take off the guide bar and check the passage of the lubricating hole.
Guide bar:
After taking off the guide bar, remove dust from the grooves and the lubricating hole.
Other parts:
Check for any oil leaks, loose mounts and damaged main parts, particularly in the location where the handles
and the guide bar are mounted. Any identifi ed defects must be repaired before the chain saw is used again.
1
2
A B
1
2
2
1