35
11. Static Check Function
26
27
28
29
30
This function is used to compare current weight result with the preset LO and HI Limit. The comparison results
(LO, OK, HI) will then be displayed by one of the Lo/OK/Hi indicators with or without buzzer
31
. Targets of Check
mode are: -
•
Weighing mode = weight value.
•
Piece Count mode = piece value.
•
Auto Tare Accumulation mode = weight value.
11.1 Set LO& HI Limit
Follow the below steps to set LO and HI Limit.
a.
During desired operation mode, press
[Check]
.
b.
Instrument displays Low followed by a 6-digital value. Enter the LO limit through numeric keys or press
[CE/x10]
to set LO limit to zero then press
[PRINT/M+]
to save.
c.
Instrument displays HIGH followed by a 6-digital value. Enter the HI limit through numeric keys or press
[CE/x10]
to set LO limit to zero then press
[PRINT/M+]
to save.
d.
Check Mode is now enabled. The check result is shown by one of the check result indicators
32
.
11.2 Hints for Entering LO and HI Limits
a.
For normal comparison, set both LO and HI Limit.
b.
To check only if result is lower than or equal to LO (result ≤ LO), set HI Limit = 0.
c.
To check only if result is higher than or equal to HI (result ≥ HI), set LO Limit = 0.
d.
To check if result is equal to a specified value, set both HI Limit and LO Limit = the specified value.
11.3 To Cancel Check Function
To cancel check function, press
[CE/x10]
on point
b
and
c
of
11.1
.
26
Check mode will not operate when weight is less than 20d (or 20d
1
for dual weighing range/interval mode).
27
Set also F15 for desired Check buzzer output and action on negative value
28
When F25 = Mode 1, set also F26 (Near Zero weight value).
29
Check mode does not support animal weighing mode.
30
Set F26 to zero.
31
Set F15 for preferred buzzer output configuration.
32
Yellow = Lo; Green = OK; Red = Hi.
