29
•
Press the preferred PLU position (numeric key 0 ~ 9), then press
[PRINT/M+]
to save to that
PLU position and utilize these limits immediately, or
•
Press
[PRINT/M+]
to utilize these limits immediately but without saving to PLU, or
•
Press
[ZERO]
to quit.
6.11.1.2 Recall weight limits from PLU
Follow the below steps to recall Lo and Hi limits.
1.
Select desired operation mode and weight unit, then press and hold
[Check]
for 2 seconds.
2.
Instrument displays
CHK =?
. Press PLU position (numeric key 0 ~ 9) then press
[PRINT/M+]
to recall
the Lo & Hi limits stored in that position.
3.
Instrument displays Lo and Hi limits and these values are now effective.
6.11.1.3 Clear weight limits from PLU
Refer to
6.11.1.1
. Enter zero value for both Lo and Hi limits in step number 2 and 3. Then press the preferred
PLU position to clear.
6.11.2 Quantity limits PLUs
6.11.2.1 Save quantity limits to PLU
Follow the below steps to save Lo and Hi limits for quantity.
1.
Go to piece count mode under desired weight unit, then press
[Check]
.
2.
Instrument displays Low followed by a 6-digital value. Enter the Lo quantity limit through numeric keys
then press
[PRINT/M+]
.
3.
Instrument displays HIGH followed by a 6-digital value. Enter the Hi quantity limit through numeric keys
then press and hold
[Check]
for 2 seconds.
4.
Instrument displays
Save =?
. At this point: -
•
Press the preferred PLU position (numeric key 0 ~ 9), then press
[PRINT/M+]
to save to that
PLU position and utilize these limits immediately, or
•
Press
[PRINT/M+]
to utilize these limits immediately but without saving to PLU, or
•
Press
[ZERO]
to quit.
6.11.2.2 Recall quantity limits from PLU
Follow the below steps to recall Lo and Hi limits.
1.
Go to piece count mode under desired weight unit, then press and hold
[Check]
for 2 seconds.
2.
Instrument displays
CHK =?
. Press PLU position (numeric key 0 ~ 9) then press
[PRINT/M+]
to recall
the Lo & Hi limits stored in that position.
3.
Instrument displays Lo and Hi limits and these values are now effective.
6.11.2.3 Clear quantity limits from PLU
Refer to
6.11.2.1
. Enter zero value for both Lo and Hi limits in step number
2
and
3
. Then press the preferred
PLU position to clear.
6.11.3 Preset Tare PLUs
6.11.3.1 Save preset tare to PLU
Follow the below steps to save preset tare value.
1.
Select desired operation mode and weight unit.
2.
Enter preset tare value through numeric keys then press and hold
[TARE]
for 2 seconds.
3.
Instrument displays
Save =?
. At this point: -
