Appendix B: - Customized PC Output Protocol
This instrument supports customized PC output protocol. Under this mode: -
•
2 data separation types
•
7 control codes, and
•
26 different transaction data
are available from instrument.
B.1 Customized PC Output Protocol Setting Procedures
1.
Go to F16 and select the preferred UART number depends on the output comport number.
2.
Select PC, then set baud rate, parity and data length.
3.
Select Custom in Protocol page and press
[Print/M+]
.
4.
Instrument displays
Separa
then followed by data separator selection page.
5.
Select preferred data separator CoMMA (comma) or SemiCo (semi colon)
[Print/M+]
.
Notes
: -
•
Data separator is a symbol inserted between transaction data and is usually used by computer
program to separate various data.
•
No data separator is inserted between in front or after control commands.
•
Separator in front and after a control code (C1 ~ C6) will not be surpassed. For example: -
STXdata
,
data
,
dataETX
•
Exception of above is when control codes are in between 2 data. For example: -
data
,
CR LF data
6.
Instrument displays Item Number, then followed by the content page.
Note: -
Item number means output sequence, e.g. Item 1 = the first content to output, Item 3 = the third
content to output.
7.
Press
[PF/Set]
and
[MR]
until the preferred content appears and press
[Print/M+]
. Refer to below
Customized PC Output Content Table
for details.
8.
Repeat step
6
to include other transaction data or control.
9.
To complete and save a customized output, select
End
and press
[Print/M+]
.
10.
Then select output time interval (refer to paragraph
s 8.1 & 8.2
for details).
11.
Press
[Print/M+]
to save.
